Philom Bios Inc.
3935 Thatcher Avenue
Saskatoon, SK Canada S7R 1A3
1-888-744-5662
www.philombios.com

How to Apply N-Prove Liquid

On Seed Directions for Use
Shake well before using to ensure an even suspension. Settling of bacteria during storage is normal.

Continuous Application

• Remove bag from box.
• Attach dosing cap and tube to the bag.
• Hang bag directly using reinforced hole, with dosing nozzle at bottom.
• Calibrate the system, to ensure that 2.1 fl oz of N-Prove flows out of the nozzle in the time that 50 lbs of seed passes beneath it.

In-Furrow Directions for Use
Shake well before using to ensure an even suspension. Settling of bacteria during storage is normal.

The bacteria used in all inoculants may be sensitive to certain chemical residues. Ensure a clean liquid delivery system is used to apply the inoculant. Remove spray tips and replace with appropriate flow regulator orifice discs, and direct the solid stream behind the seed planting assembly in the furrow. Do not apply banded to the side, below or above the seed.

Mixing Procedures
Clean the spray tank and empty the correct amount of N-Prove liquid inoculant to be applied directly into the tank. Fill the spray tank with the appropriate amount of clean, non-chlorinated water for this amount of inoculant. The addition of the water will mix the product sufficiently.

Application Procedures
For in-furrow application N-Prove liquid must be applied with the seed row. Calibrate the flow rate to deliver the correct amount depending on row width. N-Prove should be applied at a rate of 1 fl oz per 1000 ft of row. N-Prove can be diluted with water to assist in application. Diluted N-Prove may be applied at 1 gallon to 8 gallons per 2.47 acres. Use diluted N-Prove within 24 hours.

N-Prove soybean is for on-seed application only - not for in-furrow application.